Porsche 924

Extended ball-socket connector for the exterior door-handle linkage, designed to add adjustment when the lever must be pulled too far or is difficult to reconnect. It uses an extra M5 nut; the creator prints it open-slot side up without supports at 0.2 mm layers and about 15% infill.

Threaded plastic ball-socket end for the door-handle drop linkage. The creator says the lower opening must be threaded after printing.

Adjustable clutch-pedal stop intended to reduce pedal travel. The creator specifies a 60 mm or 80 mm M10 hex-head bolt and nut, two 20 mm M4 bolts with nuts, four 12 mm washers, threadlocker, and PETG.

Streamlined replacement alternator cooling duct modeled from a 3D scan of the original failure-prone part and shaped for support-free printing. The creator printed it in PA12 and reports that PETG has also been tested.

Push-on replacement caps for the screws that retain the fender; the archive supplies standard and rounded variants.

Replacement set for the heater-panel slider levers, supplied as separate upper and lower STL models.

Replacement for disintegrating heater-panel lever knobs. The single arrowless design presses onto and can be removed from the heater-control levers; it intentionally omits the faint side arrows found on two originals.

Printable replacement for the break-prone front-seat backrest release control button, modeled from the shared latch style used across the listed seat applications.

Replacement lever for the electric sunroof latch. The creator reports that a printed and installed version works; the second, fixed STL is the latest version and uses a solid peg after the split design repeatedly broke.