Porsche Cayman

Replacement side mounting rail for the HEREGOES Android head unit that replaces the factory CDR30 or CDR24 stereo. V2 uses slightly oblong holes for fit adjustment.

Glue-in replacement tab for a broken sun-visor vanity-mirror housing. The creator instructs filing away excess plastic, bonding the tab with superglue, and printing slowly or increasing minimum layer time.

Front license-plate bracket that fastens vertically into the solid grille below the factory plate area, avoiding holes in the painted body panel.

Template for marking a steel press plate used to remove the rear half of a PDK transmission case.

Clip that axially constrains lower-mainshaft components while releasing the linear distance sensor.

Adapter for mounting a Morel MT450 tweeter using four screws and screw retainers.

Three-part MagSafe phone holder that clips near the glove-box compartment on left-hand-drive interiors. Its position keeps the holder away from the gear lever and leather trim. It accepts a 46 mm-inner/54 mm-outer MagSafe-style magnet ring and the printed parts are joined with super glue.

Center-console tray remix for an iPhone 13 Pro and Anker 15W PowerWave Alloy charging pad, with added phone-positioning blocks and a lower cutout to clear the flip-up cover. It installs after removing the factory rubber liner.

Replacement retaining pin and small gear for the dashboard cup-holder mechanism. The creator thickened the pin for easier printing, increased the gear height for better mesh, and used an 18-gauge brad nail as the pivot. The parts were printed in PETG after PLA softened in a hot car.

Headliner-mounted radar-detector bracket secured beneath the passenger visor support, with tie-wrap or hook-and-loop attachment points for the detector.

Removable MagSafe phone mount that spans the top of the factory PCM screen. It holds the charging puck with 3M VHB tape, routes the USB cable toward the glovebox, and attaches using two 0.048-inch metal tabs.

Center-console tray for an Anker 15W PowerWave Alloy charging pad, sized for a cased Samsung S20+. Includes an editable tray model and a separate TPU underlay to protect the console; the creator installs both after removing the factory rubber liner.