911 996

Replacement cap for the Cabriolet hardtop-latch opening. The creator says it hides the latch mechanism, may need approximately 1% scale adjustment depending on printer accuracy, and should be printed flat-side down.

Flywheel-bolt-driven installation tool that seats the rear main seal 13 mm below the crank flange; its orientation relief clears the flywheel-flange rivet.

Replacement control knob for the Becker CDR-220 radio.

Plastic latching receptacle that fits into the front luggage-compartment battery bracket and receives the quarter-turn battery-cover screw plug.

Clutch alignment tool for a 2004 Carrera with 23 splines, 1-inch diameter and 15 mm pilot hole; includes the two tool sections and their assembly ring.

Clip fitted beneath the light switch so the lights turn on and off with the vehicle.

Replacement sliding-face-plate quadrant gear for 2002–2005 cars, supplied as left- and right-hand-drive variants.

Two-piece cup holder that mounts with the existing screws after removal of the ashtray-delete rubber liner while retaining access to the storage compartment.

Closeout panel for the center-console delete opening.

Phone holder for the shared dashboard cupholder slot; this version fits the 69 mm-wide slot and permits a USB charging connection.

Replacement for the upper square CD-case storage unit in the dashboard, with a top cable-routing port for a USB/Bluetooth module. The creator printed it in resin and reports good fit.

Replacement shaft for the instrument-cluster trip and dimmer controls, measured from an OEM stalk. The creator recommends resin or ABS for resolution and heat resistance and notes that sanding may be needed for a close fit.

Passenger/right headlight-washer cover with tabs and a companion jig used to heat-form the cover to the compound curve against the headlight housing.

Printable camshaft holding-down tool for early five-chain engines in the Boxster 986 and 911 996. The tool holds the camshafts during cylinder-head-cover removal and reassembly.

Removable cup holder that screws to a padded center-console side panel with four M3 threaded inserts and four M3 screws. The holder slides upward off its bracket for full seat travel; the supplied orientation is for the right side and can be mirrored for the left.

Flat-backed replacement clip for retaining a front dashboard tweeter when the original plastic clip has become brittle.

Separate front-dashboard and rear rings for mounting 4-inch replacement speakers. The front and rear geometries differ, and installation requires cutting the new speakers' mounting tabs and bonding their outer rings to the adapters.